As per Electronic Calibration Tester. Available imperial and metric System and following models :

Table Model Horizontal Tensile Testing Machine Cap 2 ton (20 KN)

The Tensometer can be used to test a variety of materials such as metals, plastics, timber, ceramics, cement, fabrics etc. in tension, shear, compression and bending. Available with spring beams ranging from 300 N to 20 KN (31¼ kgf to 2000 kgf) the latter in each case being the maximum lad of the machine.

ELECTRONIC TENSOMETER (METM 200 ER1) Available.
 

Top

Useful for checking Springs in tension and compression.

Spring Dia : 3 mm to 40 mm
Max. Length of Spring : 150 mm
Load Capacity : 100 kg (Max.)
Special Models Available on Demand.
 

Top

	U & V Notches
	Most Simple and Most Accurate
	Skilled operator not required
	Expensive Machines not required
	Precision regrinding of tools eliminated
	Low power requirement

Specifications :
ASTM Designation A 370,  BS 131 : PART 1:1961, PART 2&3:1972,  DIN 50115, IS/1598/1977.
 

Top

	High Resolution Guage Projection Optics
	Precision Workstages
	Bright Adjustable Profile and Surface Illumination using Fibre Optics Cold Light
	Certified Linear Scales with a choice of Three Electronic Readout & Data Processing Systems
	Precision Holding Fixtures

Available in various models as per requirement.
 

Top

150mm Cube Moulds  (other sizes available as per requirement)
Standard : BS 1881
Base Plate : M.S. 15 mm thick / 10 mm thick
Weight      : 17 kg. +/-
  

Top